A Clutch Disc Replacement cost in Lima in 2024

The average cost for a clutch disc replacement with CarAdvise is $1105 and the range is generally between $165 and $1666.

Get expert advice, compare prices, schedule, approve, & pay for any service at your favorite shops - guaranteed to be lower than in-store retail.

How CarAdvise Works

Book

Find 400+ services from a network of trusted shops and book appointments in seconds.

Approve

Approve or decline an itemized list of services and costs before any work begins.

Pay

Pay securely and enjoy exclusive discounted rates and a hassle-free checkout experience.

AVERAGE COST IN Lima

A Clutch Disc Replacement costs by shop in Lima.

CarAdvise Customers save an average of $221 on A Clutch Disc Replacement.

POPULAR VEHICLES

Average cost of A Clutch Disc Replacement for popular vehicle models in Lima:

Car Model

Avg. cost

$50

Maintenance as it's meant to be.

Transparent

Never overpay for car maintenance. Compare and select from discounted prices across 26,000+ trusted shops nationwide.

Empowering

Ignite your auto knowledge. Gain invaluable insights into maintenance schedules, service clarity, and obtain expert advice.

Hassle-Free

Bypass the stress of negotiations. CarAdvise simplifies your car care journey for an effortless experience.

THE IMPORTANCE OF A Clutch Disc Replacement

What is a clutch disc and how does it work?

A clutch disc is a component of the clutch assembly in a manual transmission system. In order to effectively switch between gears in your manual transmission, it is necessary to momentarily disengage the transmission from the engine. Otherwise, your vehicle would be in motion anytime the engine was running. The clutch is the connection between the engine and the transmission and can be alternately engaged and disengaged.

The way the clutch works is through friction between the engine flywheel and the clutch disc. The flywheel is connected to the engine crankshaft and spins with the engine. The clutch disc is connected to the input shaft of the transmission. The disc is coated with a sacrificial friction material that causes it to grab hold of the surface of the flywheel when pressed against it by the clutch pressure plate. This is the case under normal operating conditions with the clutch engaged. Since the transmission input shaft is connected to the clutch disc, the shaft turns along with the engine.

When you press the clutch pedal, tension from the pressure plate is relieved, and the clutch disc is freed from the flywheel. In this condition, the engine spins independently of the transmission so that you can select a different gear.

COMMON SYMPTOMS

How do I know if my vehicle needs a new clutch disc?

There are several signs that your clutch assembly needs attention. When the clutch is serviced, it is common for a technician to replace all related components, including the pilot bearing, pressure plate, release bearing, and clutch disc. When these components wear out or fail, you might notice one or more of the following symptoms:

Your engine seems to “run away” or rev up when you press the accelerator pedal without an increase in vehicle speed

The clutch pedal is unusually easy to press

You experience difficulty shifting between gears or from neutral into a selected gear

You hear grinding noises when shifting gears

This text is only for demo

FREQUENCY OF INSPECTION

How does a technician perform A Clutch Disc Replacement ?

Most technicians will advise that all of the components of a clutch assembly should be replaced at the same time. This is for a couple of reasons. First of all, the time that it takes to replace one of the components of a clutch is essentially the same for replacement of the entire assembly. It is also likely that, if one component is worn, the other components are in a similar condition. Therefore, it is common to replace the pressure plate, pilot bearing, and release bearing along with the clutch disc.

To replace a clutch disc, a technician must first safely lift and support your vehicle in the air for access. From there, a typical clutch assembly replacement consists of the following:



  • Removal of the driveshaft(s) and transfer case (if so equipped)
  • Removal of the clutch slave cylinder and/or clutch linkage
  • Unbolting and removing the transmission from the vehicle
  • Disassembly of the clutch assembly to remove and replace the clutch disc and other components
  • Reinstallation of the transmission, linkage, slave cylinder, and other components
  • In the case of a hydraulic clutch, the hydraulic fluid must be replaced and the system may need to be bled of any air in the fluid. Special alignment tools and procedures may also be required to properly reassemble and install the clutch assembly into the transmission.

Other Questions Customers Ask

How does a clutch burn out?
Clutches burn out when they are overheated from improper use or abuse. If a vehicle is loaded beyond its GVWR or is pulling more than its rated towing capacity, or if the driver does not engage and disengage the clutch quickly enough (also called "riding the clutch") this can cause the clutch to overheat and burn out. Frequent stop-and-go driving can also be hard on the clutch assembly.
How many miles should a clutch last?
How long a clutch should last varies greatly based on the habits of the driver. Some drivers are able to get 100K miles or more out of a clutch. Others, however, may find that they need a new clutch every 20K-30K miles.
Can I replace a clutch myself?
The procedure to replace a clutch assembly is a lengthy and relatively complex process. Not only does it involve safely lifting and supporting your vehicle in the air for access, but it also requires removal of the transmission or transaxle from the vehicle to access the clutch assembly. This is not an operation that should be undertaken by anyone who does not have significant experience and should be done by a qualified technician.

This is demo Question

This is demo Answer

Compare discounted prices at 32k+ shops.

Finding a trusted shop has never been easier. We've partnered with the largest brands in auto maintenance to give our customers the biggest network to choose from.

PepBoys Full SVG
Firestone Name SVG
Jiffy Lube Full SVG
NTB Logo SVG 1
Discount Tire Full SVG
GoodYear Logo Full SVG 1
Valvoline Name SVG
Meineke Name SVG

Trusted & partnered with leading companies.

We've earned a reputation as the go-to choice for quality car care, with some of the biggest names in business reaping the benefits and improving their customer's car care experience.

Honda
doordash
ebay
Allstate
carvana
buckle

Need to talk about something?

Call us at (844) 923-8473 or email [email protected]

Join the world's largest consumer fleet.

Over 1.8 Million already have.

Own A Repair Shop?