A Rear Main Seal Replacement cost in Appleton in 2024

The average cost for a crankshaft main bearing seal with CarAdvise is $944 and the range is generally between $61 and $2304.

Get expert advice, compare prices, schedule, approve, & pay for any service at your favorite shops - guaranteed to be lower than in-store retail.

How CarAdvise Works


Find 400+ services from a network of trusted shops and book appointments in seconds.


Approve or decline an itemized list of services and costs before any work begins.


Pay securely and enjoy exclusive discounted rates and a hassle-free checkout experience.


A Rear Main Seal Replacement costs by shop in Appleton.

CarAdvise Customers save an average of $189 on A Rear Main Seal Replacement.


Average cost of A Rear Main Seal Replacement for popular vehicle models in Appleton:

Car Model

Avg. cost


Maintenance as it's meant to be.


Never overpay for car maintenance. Compare and select from discounted prices across 26,000+ trusted shops nationwide.


Ignite your auto knowledge. Gain invaluable insights into maintenance schedules, service clarity, and obtain expert advice.


Bypass the stress of negotiations. CarAdvise simplifies your car care journey for an effortless experience.

THE IMPORTANCE OF A Rear Main Seal Replacement

What is a rear main seal and how does it work?

As an engine runs, it circulates motor oil throughout the engine block to coat all of the internal moving parts. After oil lubricates the bearings and other components, it falls back down to the oil pan in the bottom of the engine to be recycled and pumped through the engine again. Many gaskets and seals help seal up the gaps between parts of the engine so that the oil stays inside the engine block where it belongs rather than leaking out.

One of these seals is called the rear main seal. Sometimes known as a crankshaft main bearing seal, it takes up the gap between the spinning crankshaft and the engine block or oil pan flange at the rear of the engine.


How do I know if my vehicle needs a new rear main seal?

The primary sign of a bad rear main seal is an oil leak from the engine. Your engine might need this seal replaced if you notice one or more of the following:

Oil is leaking on the ground near the rear of the engine (front or right side of the engine compartment, depending on whether your engine is front or transverse mounted) or front of the transmission

Oil is leaking onto the ground, and it appears to be coming from the rear of the engine or front of the transmission

The rear of the oil pan or bottom of the bell housing is wet with oil

The engine is low on oil

This text is only for demo


How does a technician perform A Rear Main Seal Replacement ?

Rear main seal replacement requires significant access to your engine. In some cases, the engine might have to be partially or completely removed to allow access to the rear main seal. If this is necessary, repair times will be longer and include more steps.

To replace the rear main seal, a technician will generally perform the following steps:

  • Disconnect the negative battery terminal to cut power to the vehicle
  • Remove any shields, guards, covers, or ducts to gain access to the rear of the engine and front of the transmission
  • Remove any linkages, fluid lines, and wiring on the transmission
  • Support the transmission with a transmission jack, then remove the transmission mounting bolts
  • Remove the transmission
  • Remove the flywheel or flexplate
  • Remove the rear main seal
  • Install a new rear main seal
  • Reinstall the flexplate or flywheel
  • Reinstall the transmission and connect all components to the transmission
  • Reinstall any shields, guards, covers, or ducts that were removed
  • Reconnect the battery terminal
  • Start the vehicle and verify the repair by allowing the engine to warm up and observing for leaks

Other Questions Customers Ask

Can I drive my car with a rear main seal leak?
Although a bad main seal will typically not cause your engine to run poorly, it will cause it to leak oil and can eventually result in ruining the entire engine due to lack of lubrication. Because of this, driving with a bad main seal is strongly discouraged.
Does the engine have to be pulled to replace the rear main seal?
It is common that either the engine or transmission (or both) needs to be removed to replace the rear main seal. Which one depends on the vehicle make and model.
Will stop leak fix a rear main seal leak?
There are many products on the market that are supposedly designed to "repair" leaking gaskets and seals, however these are often very short term fixes and many consumers report the products actually worsening the leak in the end. The only true and correct way to stop a rear main seal from leaking is to have it replaced by a qualified professional.

This is demo Question

This is demo Answer

Compare discounted prices at 32k+ shops.

Finding a trusted shop has never been easier. We've partnered with the largest brands in auto maintenance to give our customers the biggest network to choose from.

PepBoys Full SVG
Firestone Name SVG
Jiffy Lube Full SVG
NTB Logo SVG 1
Discount Tire Full SVG
GoodYear Logo Full SVG 1
Valvoline Name SVG
Meineke Name SVG

Trusted & partnered with leading companies.

We've earned a reputation as the go-to choice for quality car care, with some of the biggest names in business reaping the benefits and improving their customer's car care experience.


Need to talk about something?

Call us at (844) 923-8473 or email [email protected]

Join the world's largest consumer fleet.

Over 1.8 Million already have.